RIMBA ELECTRO SEX STIMULATION

Side effects:

Skin irritation may occur beneath or around the electrode sites. If skin irritation persists discontinue use.

Warnings and Precautions:

·          Do not use if you wear a cardiac-pacemaker

·          Do not use if you are pregnant

·          Do not use on eyelids

·          Do not use on broken skin

·          Avoid abrupt changes in stimulation control settings

·          Keep out of reach of children

·          Turn the power box off before applying, removing or changing electrodes

·          Stimulation of areas where bones are near the skin (knee, forehead or shin) can be painful for some patients.

·          Stimulation controls, especially amplitude should be adjusted slowly.

·          Do not immerse the stimulation power box in water or other liquids.

Using the RIMBA ELECTRO SEX STIMULATOR.

Amplitude controls.

Control knobs 1 and 2 adjust the intensity of the stimulation for channels 1 and 2 respectively. The amplitude Control is marked from 1 to 8, increasing numbers indicate an increase in intensity of current. Each amplitude control also incorporates an ON/OFF switch. When either channel is turned on the green light will come on.

Indicator light

When either channel is turned ON, the green indicator light in the middle is continuous glowing. The other green lights will follow the pulse rate. When the battery is low or the unit is continuing operating over 20 minutes, the power indicator light will change from green to red. The unit will shut itself OFF, this is an auto timer system. The power box can be reset by turning both amplitude controls OFF.

Pulse Rate Control

This control regulates the frequency of stimulation from 2 to 150 pulses per second.

Pulse Width Control

This control adjusts the duration of each individual stimulation pulse width, from 50 to 250 Micro-seconds (μS)

     Mode Selector Switch

     M = Modulation mode, contraction 4 seconds, relaxation 1 second, Pulse width and Rate remain adjustable

     N = Normal mode, Pulse width is adjustable, 50-250 μS, Pulse rate is adjustable. 2 - 150 Hz

     B = Brief mode, Contraction 0.2 sec, Relaxation 0.2 sec.

Operating Procedure

The RIMBA ELECTRO SEX STIMULATION system is easy to operate and maintain, if these instructions are followed:

         1. Both Amplitude controls must be turned OFF

         2. Open battery compartment and insert 9V battery

3. Switch the mode selector as wished to M, N or B and if necessary change pulses; Width and/or Rate.

4. Close the battery compartment

5. Insert leadwire connectors into the pads or other accessory

6. Insert other end of leadwire into the black power box

7.  Place the pads or accessory on the chosen body part

8.  Slowly increase the amplitude control, make sure that the connecting parts are clean and if necessary body hair is removed.

Use a bit lubricant to create the optimal contact. (No. 3000 Electro-gel)

9.  Be sure that the amplitude is OFF before removing electrodes

10.  When you are finished, turn off the amplitude control

Technical Information for Power Box:

Power source:     9 VDC Dry Battery (Alkaline is Recommended)

Pulse Amplitude:   0 - 80 mA

Pulse rate:            2 Hz - 150 Hz adjustable control

Pulse width:         50 μS - 250 μS adjustable control

Function Mode:     Modulation, Normal, and Burst mode

Auto timer:            20 minutes

ADVICE: turn controls to maximum and select B (brief mode)

WARNING: This product is for adults only. Use at own risk.

PHONE: (0031) 76 541 44 84     E-MAIL: info@rimba.nI

FAX: (0031) 76 -542 07 03  P.O. Box 33, 4840 AA Prinsenbeek, Holland     INTERNET: www.rimba.nI